The 20W LED street lamp opens instantly and does not flicker, making it a perfect substitute for the older discharge lamps, improving the quality of lamps and greatly reducing consumption. The use of high quality profiles aluminum, and the use of large profiles, large quantities of heat, no problem, the temperature of the aluminum substrate at room temperature is less than 30 degrees Celsius. The use of imitation lumen beads, high efficient life, very suitable for low altitude lamp installation, blue paint, beautiful fashion, with glue plug, rubber cushion and sealant, waterproof effect is very high.
◎LED City circuit lights, the government's preferred brand
◎High lumen import LED chip, gold wire conductive, long life.
◎The use of die-casting aluminum lamp body, good heat dissipation.
◎It contains waterproof plugs, waterproof pads and waterproof glue, and the protection level reaches IP65
◎Antifreeze, rain prevention, lightning protection and corrosion prevention
◎Special lens for physical optics, transparent PC mask, high transmittance.
|Type||Imitation lumen beads|
|Color rendering index||Ra>80|
|Material||Aluminum + PC|
|Color temperature||3000K-7000K all available|
|Payment terms||By T.T, Western Union, L/C, etc|
This lamp adopts high brightness imported imitation lumen beads, gold wire conduction, power doubling, large volume of light, low light decay, low fever and long life. Using external power supply, authentic all aluminum lightning protection drive, placed under the lamp post, convenient maintenance. The level of waterproof and dustproof reaches IP65, lightning protection and rain protection, and high safety.
Super thick aluminum lamp shell, high quality heat dissipation, extend the service life of lamps and lanterns. The professional optical lens adopts optical principle. After special treatment, it has no spots and no spots, and its transmittance is as high as 90%. It has the advantages of rain proof and wear-resisting.
Because of small power, this lamp is usually installed within 6m, we also produce road lamp, through gas protection welding, and hot galvanizing, electrostatic spray, high temperature curing, corrosion resistance. When the lamp head is installed, connect the wire, fix it directly on the lamppost with screws, adjust the angle, and use the crane to stand up. The process is rather cumbersome. It is suggested that professionals should be installed. If there is any doubt, you can consult us.
It is mainly applicable to the installation of street lamps with lower lights, roads, rural areas and factories.